An ink cartridge, or inkjet cartridge, is a replaceable piece of an ink jet printer that contains the ink. Each ink cartridge contains one or more divided ink reservoirs.

Replacing an ink jet can be expensive, especially if you do a lot of printing. Fortunately, many manufacturers have developed refillable ink for ink cartridges. Often people can save up to 50% or more over a replacement cartridge. Ink jet refill kits contain easy to use tools and instructions for refilling an ink cartridge.

The following are general instructions to putting ink in a printer cartridge:

1. Buy an ink refill kit at an office supply store, computer store, or department store.

2. Gather all of the materials you will need to refill the cartridge. This can include: syringe, latex gloves, and paper towel

3. Remove the empty cartridge from the printer. Depending on what type of printer you have, there may be a particular method of cartridge removal. Refer to your printer manual on how to refill a unique type of ink cartridge.

4. Place the empty cartridge on a piece of paper towel.

5. Find the fill holes on the top of the cartridge by sliding your finger across the label.

6. Use a pencil or tooth pick to puncture the refill holes in the top of the ink cartridge.

7. Insert the long needle of the syringe on the refill ink bottle into the correct hole.

8. Little by little, add the ink. It is important to make sure that you do not over-fill. It is usually 10 cc for black ink and about 5 to 8 cc for colored ink.

9. Stop when you observe ink coming out of the hole. Remove the needle from the hole after expelling any remaining ink.

10. Carefully pat the cartridge contacts on the paper towel to observe a spot of ink leaking out.

11. Cover the hole with a tiny piece of clear tape. Make sure you do not transfer the colors.

Repeat steps for each ink color. There are three colors of ink: magenta, cyan, and yellow. Follow the instructions on which hole to insert each color or push a toothpick into the holes to ascertain the colors as the markings on the printer cartridge

12. Put the ink cartridge back into the printer.

13. Leave the ink cartridge in the printer for about 12 hours before using it. This will permit the sponge inside the cartridge to become uniformly soaked with the ink.

14. Print several test pages to make sure the ink is running.

There are a number of different methods to refilling printer cartridges. The benefits of refilling include that they are much cheaper than replacing a used cartridge with a brand new cartridge, and they help keep ink out of the environment which is toxic to the soil. You also will help reduce the amount of garbage going into the landfill. The next time your ink cartridge runs out of ink, consider purchasing an ink refill kit.

Data recovery companies offer a variety of products and services, but they are not equally good for your needs. Do not just accept what a company says about its success rate on data recovery. If the company says they have a 100% success rate, that in itself is cause for concern about them. In the best of circumstances, about 60 to 75% of all hard drive data can be recovered. You need to find out how the company deals with that fact and can provide you all of the backup and security you need.

You should ask some questions before you use a data recovery company to gage their success rate, experience, professionalism and services. Once you have the information you need then you can make an informed decision about which data recovery company to use,

The data backup capabilities of the company are also important to consider. Some companies have only online backup or only off site backup. If you want to be sure your data is secure, you will want both online and off site backup. Backup is so important because it is not possible to do 100% data recovery no matter what a company may tell you. Data recovery is most likely to be in the 60 to 75 % range even with the best data recovery company.

You will need to investigate the mechanical repair capabilities of the companies that you consider. If you still have a hard drive warranty in place, the company you select should be authorized to work under that warranty. The last thing you want is to lose your warranty because a data recovery company is not authorized to open the hard drive, so be sure to get verification in writing.

If you do not have a warranty on the computer or hard drive anymore, the main consideration will be the company’s capability to fix problems in an efficient and cost-effective way. You will need to know about the technical staff’s capabilities to make repairs. You don’t want to wait until mechanical problems occur to find out about data recovery company’s ability to fix mechanical problems.

Remember that your initial assessment will be a broad range quote. Try to narrow the quote down as closely as you can. It is possible for the company to determine the cause of the failure with only a few simple tests and they should pass this information onto you. Also take a close look at free assessments, as there may be clauses that state only specific cases are free.

You should have a clause in your contract that specifies that the company may not undertake tasks unless they are specified in the contract. You do not want a situation where the company does work you did not agree to and then demands payment. Otherwise, the company may charge you for bells and whistles that are not needed and you don’t want.

If your computer or hard drive is still under warranty they you should make sure that the data recovery company is authorized to maintain that warranty. You can request this information from the manufacturer stating that the company is authorized to open the hard drive without canceling the warranty. It is important to get verifiable proof as a company may claim to be authorized by all manufactures but actually aren’t.

Food photography is a very technical area of photography because you have two dimensions to master – film and food. Here are some useful tips to help you.

Let there be light

The first important technique food photographers should learn is about lighting. When photographing food you should treat it as you would any other kind of subject and make sure it is lit correctly. Many pictures can be improved by using adequate lighting. Natural light is the best light source to use, so by a window is an ideal location. Natural light cuts out the shadows, and gives the food a more natural look which all food photographers want.

Using Props

The right props can bring a simple food dish alive. Some food types like fast food is dull and lifeless so choosing the right props of fresh fruit, vegetables, plates, candles etc will make the dull become magic. To be s good food photographer you must have a special eye and flair for design. if you have this skill naturally you will fly.

If you do a lot of food photography then shopping at second hand markets can be a great way to build your box of props. You can pick up expensive items like large pots and dishes and vases for a few dollars and a smile. If you do not do much then you may have to go shopping for what you need and bill the client!

Be Quick

Unfortunately food won’t stay appealing for very long. As a food photographer you will want to be well prepared and ready to shoot your picture as soon as the dish is finished. This will give it no time to melt, collapse or lose its color. So knowing what you want the picture to turn out like will help you to prepare for the photo. One way food photographers prepare is to have everything arranged before the food is finished. By placing a temporary stand-in plate is an excellent way to get the lighting right, and when the food is finished you switch it with the finished dish and your picture is ready to be taken.

Way to improve your food photographs

One simple way is to simply use a light high quality vegetable oil and brush it on the food! This will create a high quality shiny finish that we love to see on food.

Get to know the chef

The last area to cover is working with you food professional. If you are unlucky you will have to do the presentation of the food yourself. If you are lucky and the client has a good budget you will have a chef to do the food display.

Take a few minutes before the shoot to talk with the chef and ask them how they like to work. Ask them if there is anything you need to know about the food that may not be obvious. If nothing else this will make them feel good so you will then be able to work closer and better together.